NER LUBRICATOR (one supplied) - 8 FEED LNER BR (O Gauge 7mm scale)

This is a 3D printed, using a fine ABS like resin, NER / LNER lubricator as used on a variety of NER locomotives, including the J21, J27, Q6, Q7, A2, C7 and B15 locomotives.

The photos are of an example of the item as you will receive it (one lubricator will be supplied). These are genuine photos taken with a full frame 35mm SLR and not a digital representation.

 

The holes in the hexagon nut fittings are ready to accept the pipework (these can be cleared easily using either a 0.4mm or 0.5mm drill bit). The oscillating actuating lever enters the lubricator from the back and a 0.6mm hole is included to accept the rod... if you have modelled one.

Bear in mind the size of these items when looking at the detail in the photos. This lubricator main housing is 5.9mm long, 6.2mm wide and 5.7mm high (9.0mm long including the priming wheel).

These NER lubricators are a very distinctive design and so an accurate version was required to fill a gap in the market... there is even the wing nut on the lid fixing!!